Special Accessory Sawblades; Noise Characteristics - Scheppach 19017 03902 Originalbetriebsanleitung

Special accessory sawblades

Only use original scheppach accessory!
Special sawblade
Carbide saw blade for coated furniture boards
Dimensions:
Total ø mm 250
Borehole ø mm 30
Number of teeth 80 Z
Saw blade
Universal blank blade carbide placement for longitudina-
l and lateral
cuts in wood and chipboards.
Dimensions:
Total ø mm 315
Borehole ø mm 30
Number of teeth 48 WZ
Saw blade
Universal blank blade carbide placement for longitudinal
and cross cuts in hardwood and chipboards.
Dimensions:
Total ø mm 300
Borehole ø mm 30
Number of teeth 48 WZ
Saw blade
Universal blank blade carbide placement for longitudinal
and cross cuts in solid wood.
Dimensions:
Total ø mm 300
Borehole ø mm 30
Number of teeth 72 Z
Saw blade
Special saw blade – low noise, carbide placement for
synthetically coated furniture boards.
Dimensions:
Total ø mm 300
Borehole ø mm 30
Number of teeth 60 Z
Saw blade
Universal blank blade for soft- and hardwood.
Dimensions:
Total ø mm 300
Borehole ø mm 30
Number of teeth 28 WZ
Pre-cut saw blade
Carbide saw blade for pre-cutting synthetically coated
furniture boards
Dimensions:
Total ø mm 120
Borehole ø mm 20
Number of teeth 26 Z

Noise Characteristics

Measurement Requirements in Accordance with Draft Pre-
Norm EN 1870-1: 1995-07
The values listed are emission measurements and therefore
do not necessarily represent reliable work values. Though a
correlation does exist between emission levels and
immision levels it is not possible to determine from this
with reliability whether additional safety precautions are
required or not. Factors which may influence existing work
Art. No. area immission levels are length of exposure, individual
characteristics of the work area, other noise emission
6310 4101 sources etc. (e.g. number of machines and other processes
in the vicinity). Permissable work area noise levels may
vary from country to country. The information provided
here should however enable the user to better estimate
hazards and risks.
sound power level in dB
5100 5556 idle L
operation L
sound pressure level in work area
in dB
idle LpAeq = 81.2 dB(A)
operation LpAeg = 82.9 dB(A)
A measurement error K = 4 dB applies for the emission values
Dust Emission Data
5100 5504 The dust emission levels measured in accordance with the
"Guidelines for Testing Dust Emission (Concentration
Parameters) of Wood Processing Machines" issued by the
Committee of Wood Experts are below
2 mg/m
levels for wood dust which apply in the Federal Republic of
Germany is ensured if the machine is connected to a proper
operative suction unit with an air speed of not less than 20
5100 5507 m/s.
7986 3001
5100 5501
5472 0313
= 89.7 dB(A)
WA
= 93.3 dB(A)
WA
listed.
. This means compliance with the TRK air quality
3
english 20