Key Automation CT10324 Anleitungen Und Hinweise Zu Installation Und Einsatz Seite 26

EN
4.5.2 DELETING A BUTTON OF A REMOTE CONTROL
If you are in programming mode, press the
(DOWN-RADIO) button for more than 2 seconds. Until the display shows the word
release the button
1. Press and hold the
button.
2. Within 7 seconds press the button of the remote control to be deleted, holding it down until the KEY LED goes
out. Release the remote control button
3. About 1 second after the button is released, the KEY LED starts to flash
4. Confirm the deletion by pressing the
5. If the deletion of the button has been successful, KEY LED will give one long flash
N.B If no commands are given for 7 seconds, the receiver automatically quits the programming mode
WARNING! If the transmitter you wish to delete was originally stored using the
deletion procedure mentioned above will erase all functions associated with the buttons of that transmitter.
4.5.3 CLEARING THE ENTIRE RECEIVER MEMORY
If you are in programming mode, press the
(DOWN-RADIO) button for more than 2 seconds. Until the display shows the word
release the button
1. Press the (DOWN-RADIO) button and hold it down until the LED lights up (about 3 seconds) and then goes
out (about 3 seconds). Release the button.
2. About 1 second after the button is released, the KEY LED starts to flash
3. Press the (DOWN-RADIO) button as the LED flashes for the third time
4. If the deletion has been successful, the KEY LED will give one long flash
4.6 - Default procedure
The default procedure will reset the system to the factory settings and, if necessary, will allow to change the motor type.
To proceed, enter the ADVANCED MENU: press and hold for 5 sec. the
until appears. Press the
ATTENTION! ONLY if you need to change the type of motor, change the number with
Press and hold the (MENU) button, a countdown starts: 49, 48, ..., 1 until
4.7 - Customising the system - Basic menu
If necessary, users may select a BASIC MENU which allows modi-
fication of the control unit's basic parameters. To select the BASIC
MENU proceed as described below.
Exampling of modifying a BASIC MENU parameter:
Press the (MENU) button
and hold it down to access the
BASIC MENU.
26
(MENU) button to exit until
(DOWN-RADIO) button until the LED lights up (about 3 seconds), then release the
(DOWN-RADIO) button
(MENU) button to exit until
(MENU) button for 1 sec. to see the type of motor selected
After accessing the BASIC
MENU, press the
and (DOWN) button to
scroll through the functions.
appears. Press the
appears. Press the
(MENU) button. Scroll the menu with
appears. Release the button.
ATTENTION !
To be sure of accessing the NORMAL OPERATION display
state, the starting point for accessing the BASIC MENU, press
the (MENU) button twice.
To access the value modifi-
(UP)
cation function, press the
(MENU) button for 1 second,
until the value starts to flash
quickly.
(radio), then
'
(1s) +
output (see chapter 4.5.1, phase 1), the
(radio), then
'
(>3s)->
(1s)+
(UP) (DOWN-RADIO)
(UP) or (DOWN)
Press the or
to modify the value.
►
►
(1s) +
3s
(>3s)->
(1s)+
3s
buttons to