Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4° automatic opener use at this step
(continued)
5° remote control unit checking
6° check of the photoelectric cells
7° check of the control by a door phone
or a push button
8° The ATCR2 does not work
remains blocked
react
recorded on the board.
Memorisation of the remote control units:
- Press P2/Radio, the red LED lights up
- Press the remote control unit, the board red
LED flashes
- Wait the red LED switches off
occurs, but the red LED on the board lights up
occurs, but the red LED on the board does not
light up
alignment of photoelectric cells is correct
Note:
the installation of the photoelectric cells must be
OBLIGATORILY validated by a memorisation of
the board
the leaves do not stop the red LED lights up, and
the photoelectric cells click when passing
not at the closing
The gate opens and closes permanently or remains
blocked
Check the installation.
Reminder: The 60 sec time delay is not adjustable.
22GB
WEAT V2 N - V1
If you have connected a door phone or a push
button, check that the control signal is a dry
contact normally open. Disconnect this control
to ensure this does not cause the problem
WE 8111 bis module
the contact normally open
terminals and
terminals
control units
units, use an optional WE ATAN 2 antenna
- check the connection of the photoelectric
cells
- properly align the photoelectric cells
closure
COM and GND on the RX photoelectric cell
cells are not reversed
If you have connected a door phone or un push
button, check the control signal is a dry contact
normally open. Disconnect this control to
ensure this does not cause the problem
WE 8111 BIS module
the contact normally open
WEATCR 2,
supplied
Neutral
GND
COM
TRIG
NO
Live
V in
Werbung
