Werbung
CAUTION
This product contains a laser diode of higher class than 1.
To ensure continued safety, do not remove any covers or
attempt to gain access to the inside of the product.
Refer all servicing to qualified personnel.
Demo Function
The Demo mode starts automatically
when the power cord is plugged
into the power outlet.
Also, when the ASES/COPY (DEMO) button is pressed for more than
3 seconds in the STANDBY mode, the Demo mode is activated.
In the demo mode, various functions of this system appear on the
display.
@ The Demo mode can be cancelled by pressing the POWER button
or function button.
e@ When the ASES/COPY (DEMO) button is pressed for more than
3 seconds in the demonstrate mode, the demonstration stops
and the demonstration
function
is cancelled.
When
the
demonstration function is cancelled, the demonstration is not
carried out even when the power cord is connected again. To
resume demonstration function, press the ASES/COPY (DEMO)
button for more than 3 seconds in the standby mode.
THE POWER SWITCH IS SECONDARY CONNECTED AND
THEREFORE DOES NOT SEPARATE THE UNIT FROM MAINS
POWER !S THE STANDBY POSITION.
CAUTIONS REGARDING HANDLING ©
4
The following caution label. appears on your unit.
Location: rear of the unit
CLASS 1
LASER PRODUCT
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
in some countries or regions, the shape of the power plug and power
outlet may sometimes differ from that shown in the explanatory
drawings. However, the method of connecting and operating the unit
is the same.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet
as this could cause a short circuit or electric shock. Do not place the
unit, a piece of furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords. The power
cords should be routed such that they are not likely to be stepped on.
Adamaged power cord can cause a fire or give you an electrical shock.
Check the power cord once in awhile. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
Install the unit in a well-ventilated location where it will not
be exposed to high temperatures or humidity.
Do not install the unit in a location which is exposed to direct rays of
the sun, or near stoves or radiators. Excessive heat can adversely
affect the cabinet and internal components. Installation of the unit in
a damp or dusty environment may also result in a malfunction or an
accident (avoid installation near cookers, etc., where the unit may be
exposed to oily smoke, steam or heat).
Ventilation
When installing this unit, make sure to leave space around the unit for
ventilation to improve heat radiation (at least 30 cm at top, 15 cm at
rear, and 15 cmateach side). If not enough space is provided between
the unit and walls or other equipment, heat will build up inside,
interfering with performance or causing malfunctions.
2
<ARE7140>
En
Precautions regarding installation
Placing and using the unit for long periods on heat-geneating
sources will affect performance. Avoid placing the unit onheat-
generating sources.
Install the unit as far away as possible from your TV. Installation in
close proximity to such equipment may cause noise or degradation
of the picture.
Such noise may be particularly noticeable when an indoor antenna
is used. In such cases, make use of an outdoor antenna, or tun off
the power to the unit.
Please place this unit on a level surface.
When this unit is brought into a warm room from previously cold
surroundings
or when
the room
temperature
rises shirply,
condensation may form inside, and the unit may not be able toattain
its full performance. To prevent this, allow the unit to stand for spout
an hour before switching it on, or raise the room temperature
gradually.
Werbung
