Seca mBCA 555 Bedienungsanleitung Seite 184

Fault/error code
010-288XX-XXX
019-288XX-XXX
020-288XX-XXX
022-288XX-XXX
050-280XX-XXX
052-280XX-XXX
053-280XX-XXX
10.6 Restarting the device
Using the "Restart" menu function
184 • seca 555/554/552; seca 550/549; seca 257/256
Cause
Update failed
Overcurrent at USB interface of weigh-
ing platform
No connection to
seca connect 103
software
Overcurrent at USB interface of multi-
functional display
Internal device communication error
Communication error between weigh-
ing platform and multifunctional display
In individual cases (e.g. following implausible input) it may be necessary to
restart the device. To do so, use the
the power supply and then restore it.
NOTE
All the individual settings in the device are retained in the event of a
restart. If you want to reset the device to factory settings, proceed as
described in the relevant section:
1. Make sure that there is no load on the weighing platform.
2. Press the
ð The
Settings
3. Press the
• Restart update
• If the error recurs, inform seca Service
• Check connected USB device
• If the error recurs, do not use the USB
device
• Repeat measurement
• Check Workflow settings for the
seca connect 103
software
è Restarting the device, page 184
•
• If the error recurs, inform seca Service
• Check connected USB device
• If the error recurs, do not use the USB
device
è Restarting the device, page 184
•
• If the error recurs, inform seca Service
è Restarting the device, page 184
•
• If the error recurs, inform seca Service
Restart
è Factory settings, page 173
key.
menu is displayed.
or key until the Restart
Remedy
or seca analytics 125
function in the menu or interrupt
menu item is displayed.