Seca mBCA 555 Bedienungsanleitung Seite 145

Viewing the bioimpedance measurement analysis
6.7 Completing the measurement
Stand-alone operation
ð The device automatically starts the test for electrode contact:
ð If the electrode contact is correct, the corresponding electrode indicator
goes green.
ð When all electrode indicators are green, the measurement starts auto-
matically.
ð Once the measurement is complete, the main screen is displayed again.
8. Complete the measurement
9. Ask the patient to step off the weighing platform.
The seca analytics 125 software is required to display bioimpedance measured
è Compatible seca
results and analyses
To complete a measurement on devices that are not connected to an EMR Sys-
tem or the
seca analytics 125
1. Make sure that the displayed measured values are plausible.
2. Transfer the displayed measured values to the patient file manually.
3. Ask the patient to step off the weighing platform.
4. Press the key.
ð Measured values and manual entries are discarded.
ð The device is ready for the next measurement.
è Completing the
measurement, page 145.
products, page 198.
software, proceed as follows:
English
Operation • 145