Seca mBCA 555 Bedienungsanleitung Seite 129

5.7 Adapting device settings
5.8 Transporting device
You have the following options for setting the device up for different usage situa-
tions:
è Changing device mode, page 147
•
è Calling up/exiting a menu, page 148
•
è Setting up network functions, page 161
•
è Calibrating ultrasonic measuring rod, page 152
•
The device has two casters that facilitate transport over short distances.
CAUTION!
Injury, damage to device
The device must be tilted for transport. If the device is tilted and trans-
ported carelessly, this may lead to injuries and damage to the device.
► Ensure that there is no-one else in the immediate vicinity through-
out the entire transport operation.
► Ensure that there are no objects in the immediate vicinity through-
out the entire transport operation.
1. Remove the drip guard.
2. Disconnect all the device cable connections (e.g. power supply, network).
3. Tilt the device until it can be moved freely on the casters.
4. Transport the device to its new setup location.
5. Set up the device.
6. Re-establish all cable connections.
7. Install the drip guard.
English
Starting up device • 129