clage ISX Gebrauchs- Und Montageanleitung Seite 51

5. CLAGE app "Smart Control"
When the fill quantity is reached, "0 l" flashes briefly on the display and the appliance
stops the water flow by closing the motor valve. A long acoustic signal can also be
heard and an instruction message appears on the display. The motor valve remains
closed until the message is acknowledged via the app or remote control (only possible
with the app when connected via Bluetooth).
Turning off the tap is always necessary, the function must therefore not be used unsu-
pervised.
Before using the bath, make sure that the water temperature is what you want it to be.
Hint: The water amount of the last draw-off is stored in the "Statistics" menu. To
determine the necessary amount of water for your bathtub, fill it with warm water,
then select "Statistics" in the main menu and read out the value of this last drawing.
Enter this value in the automatic function "Fill-Up" to use it for the next bathtub filling.
Note: In the event of a power cut whilst the automatic is running according to the
fill quantity, the water flow is stopped by the motor valve. After power is restored
the valve remains closed a prompt appears on the display and an alarm signal can be
Statistics
The statistics save the consumption and usage data for the appliance and display them
in graph format:
Water consumption
Power consumption
Total consumption costs
Wipe from right to the left to scroll the different periods (only for client opera-
tion with an Internet connection). The consumptions are displayed consecutively in
diagrams over a period from the last drawing of water, the consumption today, the
consumption yesterday, over the last seven days, the last four weeks, the last twelve
months and the last four years.
Note: The consumption data are not suitable for billing purposes.
Settings
This menu is used for the basic configuration on the appliance. Wipe to scroll through
the different menu items and tap on the values to change settings directly or go to dif-
ferent submenus.
Thermal treatment: With this function, you can support a thermal treatment of your
appliance and the following pipeline, including the tap. A thermal disinfection accord-
ing to the accepted rules of technology is not replaced. For security reasons, this func-
tion can only be started with the app when connected via Bluetooth.
• Tap OK to start the treatment cycle and the outlet temperature is set to 70 °C. The
function is disabled if the appliance is connected to a shower.
• Draw hot water for at least three minutes to heat the pipes to the tap completely.
• A change of the temperature or 30 sec without water flow terminates the treat-
ment cycle.
• The number as well as the accumulated duration and the water amount of all ther-
mal treatments will be saved.
Notes:
Ensure that no one can be injured by the elevated temperatures and that the installa-
tion can withstand the strain.
The exiting water and the tap become very hot! The water steam should not be
inhaled.
51
CLAGE
EN