clage ISX Gebrauchs- Und Montageanleitung Seite 47

5. CLAGE app "Smart Control"
Apple
A
B
Initial operation
The Smart Control app can be connected to the ISX either via Bluetooth or via
WLAN. The functions that are only available with one of the two connection types are
described below.
1. Make sure that the instantaneous water heater is supplied with voltage.
2. Install the control app on your tablet / smartphone. Search the Apple App Store or
the Google Play Store for "CLAGE Smart Control" and install the app. Do not start
the control app yet.
Android
Connecting via Bluetooth
1. Activate the Bluetooth function of your smartphone / tablet.
2. Start the Smart Control Control app and confirm all security prompts.
Note: No location-related data is processed. Activating and accepting the location
function is required due to new guidelines for all Android apps with Bluetooth func-
tion.
3. A message appears the first time the app is activated. Tapping on "OK« takes you
to the device configuration "A" for manual setup (menu path: Main menu
Settings → Devices).
4. If no appliances are listed yet, select "Bluetooth connections" and tap on "Search
appliances...".
5. A maximum of ten Bluetooth devices found are then scanned and listed "A«. The
device name is composed of the model abbreviation and the last 4 digits of the
serial number. If your device is not included, repeat the scan.
6. Select your appliance from the list and tap the adjacent
7. To connect, enter the Bluetooth PIN manually or scan the adjacent QR code "B".
Can be found on the rating plate on the instantaneous water heater.
8. The appliance is now paired with your smartphone / tablet. Check the function by
changing the temperature via your smartphone / tablet. The display on the appli-
ance must show the same value.
Note: If you have already connected the app to the ISX via WLAN, you can establish
a new connection via Bluetooth if you deactivate the WLAN function on your smart-
phone / tablet.
Connecting via WLAN
The WLAN of the ISX is deactivated at the factory and starts in access point mode
after activation. To activate, open the service menu on the appliance (see chapter "3.
Use" section "Service menu").
1. Activate the WLAN function of your smartphone / tablet.
2. Establish the connection between the tablet / smartphone and the instantaneous
water heater:
3. In the tablet / smartphone, select the Wi-Fi area under Settings and connect the
tablet / smartphone to the Wi-Fi of the instantaneous water heater.
The SSID, password and a QR code for logging in can be found on the type plate on
the instantaneous water heater. Scan the QR code or enter the data manually.
4. Start the Smart Control app and confirm the initial setup prompt with "OK". You
will be taken to the appliance configuration (menu path: Main menu
→ Devices) and can check the successful installation by selecting the ISX server and
tapping "Connect...". The following text should be displayed: "The Home Server can
be used".
Note: The connection via Bluetooth is disconnected as soon as a connection via
WLAN is activated.
47
CLAGE
→
.
→ Settings
EN