clage ISX Gebrauchs- Und Montageanleitung Seite 46

ISX
4. Remote control
EN
A
B
C
D
Technical data
Model
Operating voltage
Type of battery
Type of protection
Transmission range
Transmission power
Transmission and receiving
frequency range
Radiation
Approvals
1) Do not use rechargeable batteries.
Connecting the remote control to the instantaneous water heater
1. Make sure that the power supply to the instantaneous water heater is switched on.
2. After inserting the batteries into the radio remote control (fig. A), the language
selection appears. Select your preferred operating language and confirm with
"OK«.
3. A maximum of ten Bluetooth devices found are then scanned and listed (fig. B). The
scan can be repeated by selecting
4. Select your instantaneous water heater and confirm with "OK«. The PIN entry
appears (fig. C).
5. Enter the first four digits of the Bluetooth PIN and confirm with "OK«. The PIN can
be found on the type of the instantaneous water heater.
6. The remote control is now connected to the instantaneous water heater and starts
data synchronisation (fig. D). This may take a few seconds. The remote control then
switches to the Main control.
7. Test the function by changing the setpoint via the remote control and checking the
water temperature.
If the registration was not successful, the message "Connection failed" appears briefly.
The view then changes back to the list with the Bluetooth devices found.
If your device is not found even after several attempts, check the plug-in position of
the radio adapter.
Notes:
• After replacing the batteries, a new registration is not required.
• Only register again after performed factory reset or when the remote control dis-
play continually indicates "No device connected".
Safety notes
• At malfunction of the remote control remove the batteries immediately.
• Do not expose the remote control to moisture.
• Flat batteries can leak and damage the remote control. Hence, replace flat batter-
ies right away as soon as battery symbol lights up in the display or the remote con-
trol does not response after keystroke.
• When the remote control is not to be used in the long term, remove the batteries.
• Without working radio connection, the appliance heats to the prior selected set
value.
46
FX Next Remote control
3 V
2x AA Alkaline
1)
IP 24
10 metres incl. barrier
< 8 mW
2.4 – 2.4385 GHz
undirected
Europe EN 300 328 / CE
.