clage ISX Gebrauchs- Und Montageanleitung Seite 41

4. Remote control
Main screen
The e-paper display changes automatically to main screen approx. 15 seconds after
activation or operation.
Various user profiles and applications can be selected or temperature changes made
by simply tapping one of the sensor buttons.
Temperature display
Status display, top
User
Menu button
Temperature display
The scale ring fills up as the temperature setting is increased. When water is flowing,
the ring shows the power consumption (to enable in Settings). In addition, the target
temperature is displayed in °C in the middle of the display.
Temperature setting
The desired temperature can be selected via the two middle sensor keys within a range
of 20 °C to 60 °C. Tapping once changes the temperature by 1 °C, in the comfort range
between 35 and 43 °C by 0.5 °C. If the temperature is set below 20 °C, the symbol
appears in the temperature display and the appliance switches off the heating function.
User selection
Up to four user profiles can be created. Every user has the option to save his desired
temperatures for the different application in his profile. The user profiles can be select-
ed by tapping on the left sensor key and than tap the key under the profile picture (to
adapt profile, see Section "User").
Applications
Preset applications can be selected here out of two different usage profiles for kitchen
and bathroom (to change the usage profiles, see section "Settings"). Simply tap on the
right sensor key to open the selection. Tap on the sensor key under an application sym-
bol to activate it.
The applications are factory-set to the following temperature values depending on the
usage profile:
Profile bath
Individual application = 35 °C,
tub = 40 °C.
Profile kitchen
Individual application = 42 °C,
cold water = heating off.
To change the values select an application and set the new temperature. Than press
and hold the sensor key under your profile picture or under the application symbol for
two seconds.
Status display, top
Control lock active (PIN)
The inlet temperature exceeds the target value (appliance does not heat up)
Radio connection interrupted
41
Battery status
Status display, bottom
Applications
Sensor keys
hand wash = 35 °C, shower = 38 °C,
hand wash = 35 °C, hot water = 48 °C,
CLAGE
EN
bath