Werbung
1-6-43. Capstan Motor Replacement
1, Remove the reel belt (1).
2. Remove one screw (2) from the bottom of the me-
chanical deck, and remove the PC board (3).
Note:
¢ Take care not to misuse the screw with others.
Screw (2)
PC board (3)
Reel belt (1)
Fig. 6-43-1
3. Remove the capstan motor (4) after removing three
screws (5),
Note:
* Take care not to drop the capstan motor.
Screws (5)
Mechanical
deck
Capstan
motor (4)
4. Take care not to damage and scratch the motor itself,
and mount the capstan motor (4) fitting the hole (A)
on the mechanical deck and the hole (B) on the
capstan motor (4).
Hole (B)
Capstan motor (4)
Fig. 6-43-3
5. Mount the capstan motor (4) with three screws (5)
viewing from the top side of the mechanical deck.
Capstan motor
We shaft
~
Fig. 6-43-4
No clearance is allowed.
Note:
¢ Do not use once-removed screws again.
¢ Take care that no clearance is allowed when securing
three screws.
6. After replacement, mount the parts in the reverse order
of removal.
Note:
¢ In this case, take care not to twist the reel belt and
stick the grease or etc. on it.
7. After replacing, perform the adjustment accord ng £0
the tape transport adjustment procedures.
2-33
Werbung
