2. REMOVAL OF THE CABINET
(1) Disconnect the plug from the inlet.
(5) Remove the connector (KDB unit side) of the Shuttle
(2) Remove the three screws @ securing the top cover ©.
unit, and remove the front panel ©.
(3) Unlock two hooks at both left and right of the rear
side,and slide the top cover ® backward to remove.
(4) Remove left and right insulators. Insulators ® can be
remove by unfastening the hook of the chassis
inserting a bar into the hole © located on the bottom,
and by sliding it to the arrow mark direction.
0094M 3DNR PC Board
0030M Terminal PC Board
-——
0150M Power PC Board
0212M FCB PC Board
0005M Main PC Board
0213M JSB PC Board
0210M KDB PC Board