Werbung
Center gear post (7)
Idle arm (6)
Holder center
post assembly
Idle
up/down lever (5)
Insert the arm of the idle up/down
lever into the idle arm groove.
Fig. 6-34-2
1-6-35. Holder Center Post Assembly
Replacement
1. Turn over the mechanical deck and remove the center
gear pulley and the idle arm. (Refer to item "1 -6-34.
Idle Arm Assembly Replacement.)
2. Turn over the mechanical deck and remove the top
bracket and the cassette holder assembly. (Refer to
item "1-6-1. Top Bracket Assembly Replacement and
1-6-2. Cassette Holder Assembly Replacement".)
3. Remove the drive arm assembly. (Refer to item "1-6-
5. Drive Arm Assembly Replacement".)
4. After removing two screws (1), replace the holder
center post assembly (2).
5. After replacing, mount the parts in the reverse order of
removal,
Screw (1)
Holder center
post assembly (2)
Apply a few
drops of oil.
Holding post (3)
Fig. 6-35-1
Note:
¢ When mounting, push the cutout (A) on the holder
center post assembly (2) aligning with the projection
on the mechanical deck.
* Screw tightening torque is 294 — 392 mNem (3 — 4
kgecm).
¢ Before mounting the center gear pulley, apply a few
drops of oil. (Refer to Fig. 6-34-1.)
1-6-36. REC Inhibiting Lever Replacement
1. Remove the top bracket. (Refer to item "1-6-1. Top
Bracket Replacement".)
2. Remove the cassette holder assembly. (Refer to item
"1-6-2, Cassette Holder Assembly Replacement".)
3. Remove the cam slider. (Refer to item "1-6-41. Cam
Slider Replacement"'.)
4. Remove the tension spring (2).
5. Undo the claw (A) on the S soft brake (1) sliding and
lifting it upward.
6. Remove the projection (B) on the REC inhibiting
lever (3) sliding in the direction shown by the arrow
and lifting it upward.
7. After replacing the REC inhibiting lever (3), mount
the parts in the reverse order of removal.
Tension spring (2)
Claw (A)
REC-inhibiting
lever (3)
Projection (B)
Fig. 6-36-1
Werbung
