Werbung
1-6-4. Drive Lever Gear Replacement
1. Make the cassette holder assembly to the slot-out
(EJECT) position.
Note:
¢ In this condition, both mark holes on the F/L drive
slider (1) and the mechanical deck fit with each other,
also the hole of the boss on the drive lever gear (2),
the center of the gear tooth and the marking line are in
line.
2. Move the claw of the drive arm (3) to the direction of
the arrow (A) and remove the drive lever gear (2)
upward.
F/L drive
Mark hole
slider (1)
Marking
Claw
Drive lever gear (2)
Drive arm (3)
Fig. 6-4-1
3. When remounting the drive lever gear (2), take care of
the phase position (refer to the note described above.)
and mount in the reverse order of removal.
*
1-6-5. Drive Arm Assembly Replacement
1. Remove the top bracket assembly. (Refer to item "1-6-
1. Top Bracket Replacement".)
2. Remove the cassette holder assembly. (Refer to item
"1-6-2. Cassette Holder Assembly Replacement".)
3. Remove the door open lever. (Refer to item "1-6-3. '
Door Open Lever Replacement.")
4. Remove the drive lever gear. (Refer to item "1-6-4.
Drive Lever Gear Replacement'".)
5. Pull the REC-inhibiting lever slightly to the front side,
turn the drive arm assembly (1) to the front side and
push it in the direction shown by the arrow. Remove .
the left side boss (2) on the drive arm assembly (1)
from the cutout of the guide groove on the mechanical
deck (3).
6. Remount the drive arm assembly (1) in the revei%e
order of removal.
Drive arm assembly (1)
—=
Left side boss (2)
Drive arm assembly (1)
Cutout of the
guide groove
Mechanical
deck (3)
Fig. 6-5-1
Werbung
