Werbung
1-6-33. T Reel Table Assembly and Washer 2
Replacement
1. Remove the top bracket and the cassette holder
assembly. (Refer to item "1-6-1. Top Bracket Replace-
ment and 1-6-2. Cassette Holder Assembly Replace-
ment".)
Remove the drive arm assembly. (Refer to item "1-6-
5. Drive Arm Assembly Replacement")
. Remove the T soft brake and T main brake assembly
(Refer to item "1-6-41. Cam Slider Replacement".)
. Remove the T reel table assembly (1) pulling it out
upward.
5. Remove the washer 2 (2).
. After cleaning the reel shaft (3) with a cleaning kit,
insert a new washer 2 (2) to the reel shaft (3) and
apply a drop of oil to the shaded portions (two
locations) on the reel shaft (3).
After replacing, mount the parts in the reverse order of
removal.
Confirm the reel torque using a torque cassette.
T reel table
assembly (1)
Black
Washer 2 (2)
Reel shaft (3)
Fig. 6-33-1
Note:
*
Washer 2 (2) can use repeatedly.
2-28
1-6-34. Idle Arm Assembly Replacement
(Center Gear Pulley, Idle Kick Lever,
Idle up/down Lever)
1. Remove the mechanical deck from the main PC board.
. Remove the stop ring (1) turning over the mechanical
deck.
. Remove the center gear pulley (2) lifting it upward.
. Remove the claw (A) on the idle kick lever (3)
moving and pulling it upward.
. Remove the slit washer (4).
. Remove the idle up/down lever (5) and the idle arm
(6) simultaneously from two claws (B) on the me-
chanical deck.
. After cleaning the center gear post (7) using a cleaning
kit, apply a few drops of oil to the shaded portion on
the center gear post.
8. Mount the parts in the reverse order of removal.
Note:
¢ Stop ring (1) is impossible to use again.
¢ When mounting the parts, take care of the notice
shown in Fig. 6-34-2.
age Stop ring (1)
Center gear
pulley (2)
Idle kick
lever (3)
Idle up/down
lever (5)
Center gear post
Apply oil.
Holding post
Fig. 6-34-1
Werbung
