Werbung
1-6-44. S-VHS Switch Assembly Replacement
1-7.
Check and Adjustment
(S-VHS model only)
1. Slide the cassette holder assembly (1) until the screw
1-7-1. Check of Tension Pole Position
(2) can be seen from the hole on the top bracket (3).
1. Turn the worm wheel counterclockwise after remov-
2
:
ing the cassette holder assembly on the front loading
2. Insert a screwdriver from the hole provided on the top
'
oe
mechanism, and set the cam gear at playback position.
bracket (3) and secure the screw (2).
:
2. Turn the S reel table assembly (1) clockwise slowly.
3. Remove the S-VHS switch assembly (4) upward.
;
3. Adjust the adjuster (3) counterclockwise from the
4. After completion of the replacement, mount the parts
ok
en
an
oa
;
position shown in Fig. 6-23-1 so that the clearance
DEHRS REVERSE ORO CE OF TEINOYAY
between the left end of the tension lever assembly (2)
and the left side of the mechanical deck becomes 7.5 +
1 mm.
Screwdriver
*
Pa
Note:
_
¢ There is a long mark at the position of 7.5 mm from
Top bracket (3)
the round surface of the mechanical deck. Make sure
the position of the mark when adjusting.
Mark
Cassette holder
assembly (1)
Screw (2)
7.5+ 1mm
S-VHS SW
7
assembly (4)
'
Tension lever
assembly (2)
Long
S reel table
mark
assembly (1)
Fig. 6-44-1
>
oy
r
Adjuster (3)
Fig. 7-1-1
2-34
Werbung
