Werbung
Note:
* Confirm that the joint portion (E) of the elastic spring
positions in front of the assist pin (F) on the cleaner
assist lever (4).
a
lever (1)
Assist pin (F)
Joint portion (E) of
elastic spring
x
Cleaner assist a
lever (4)
Fig. 6-14-3
1-6-15. No. 8, No. 3 Guide Sleeves Replacement
1. When replacing the No. 8 guide sleeve (1), first
remove the guide cap (2) on the loading bracket
assembly.
2. Pull out the guide sleeve (1) from the guide post (3).
Note:
* Take care not to break the No. 8, No. 3 guide posts on
the mechanical deck if twisting the guide sleeve
forcefully.
3. Insert a new guide sleeve (1) to the guide post.
Note:
* When inserting the guide sleeve (1), take care so that
its hole faces the opposite side to the tape transport
surface.
4. For No. 8 guide sleeve, insert the No. 8 guide cap (2)
onto it.
No. 8 guide cap (2) (In case of No.8 guide cap)
(Loading bracket assembly)
Guide sleeve (1)
(
h
Fig. 6-15-1
Hole
~
=>
Guide sieeve (1)
Ss
Guide post (3)
2-17
1-6-16. ACE Head Assembly Replacement
1. Remove the FFC (1) from the connector.
2. Remove two screws (2) and remove the ACE main
base (3) and ACE head assembly (4).
3. Remove three adjusting screws (5), (6), and (7) and
then remove the ACE head assembly (4).
Note:
« When replacing ACE head (9) only without replacing
its PC board, unsolder the ACE head (9) on the ACE
head PC board (8) and then remove the ACE head (9)
and the ACE head PC board (8).
4. Mount the ACE head assembly (4) in the reverse order
of removal.
Note:
¢ When reassembling the ACE head assembly (4), First
set the ACE springs (10) between the ACE head
assembly (4) and the ACE main base (3), and secure
the adjusting screws (5), (6), and (7).
Connector
FFC (1)
ACE height
adjusting screw (7)
ACE tilt
adjusting screw (5)
ACE azimuth
adjusting screw (6)
ACE head PC board (8)
ACE head assembly (4)
ACE head (9
©)
ACE springs (10)
ACE main base
fixing screw (2)
Convex portion of
x
round surface
> boss
AA
|
ACE main base (3)
ACEmain base
fixing screw (2)
Fig. 6-16-1
Werbung
