Werbung
7. Undo the hook of the Terminal board (20) by pressing
it and lift it up.
Hook
(20) Terminal Board
Fig. 5-1-3
8. Remove the mechanical deck (14) with main unit (8)
from the chassis lifting its rear side slightly and
pulling it upward.
Fig. 5-1-4
Note:
When pulling the top bracket upward, take care not to de-
form the reinforcement plate located below the F/L assem-
bly.
9. Remove the lead wire connecting between the me-
chanical deck (14) and the main unit (8).
10. Turn over the mechanical deck (14).
11. Remove the reel belt (21) and one screw (22).
12. Remove four claws securing the mechanical deck (14)
and the main unit (8), and then remove the main unit
(8) pulling upward.
1-5-2. Mechanical Deck Mounting
1. Turn over the mechanical deck and lower the main unit
vertically adjusting the tape end sensor and etc. to the
holes.
Note:
¢ Adjust the rotor of the cylinder motor and the stator of
the main unit,and then lower the main unit further more
till four claws catch the mechanical deck completely.
* Take care not to damage the rotor and the stator.
* When locking the claw of the front right side to the
main unit, turn the REC inhibit lever so as not to dam-
age the switch.
2. Mount the mechanical deck on the chassis in reverse
order of removal.
Note:
When mounting the front panel, mount it with its door
fully open.
1-5-3. Confirmation of Each Operation Mode
without Cassette
1. Shut out the light to the start/end sensor.
2. Release the both sides of the lock lever and make a
slot-in condition.
3. Turn the reel table manually located on the opposite
side of the rotating reel table.
4, In this condition, confirmation of each operation
mode can be performed.
Note:
When turning the opposite side reel table of the rotating
reel table manually in playback, FF/REW mode, and send-
ing no reel pulse, the auto eject or power off function is
performed.
Werbung
