Werbung
1-5.
Mechanical
Deck Removal
and
3. Remove the connector (4) (KDB unit side) of the JSB
unit, and remove the front panel (3).
Mounting
4, Remove the FFC (7) connecting between main unit (8)
1-5-1. Mechanical Deck Removal
and KDB unit (5), lead wires (9) and (10) connecting
1. Remove three screws (2) mounting the top cover (1)
between terminal unit (12) and FCB unit (6), lead wire
and unlock two hooks at both left and right of the rear
(11) connecting between main unit (8) and FCB unit
side, then remove the top cover sliding backward and
(6). Remove lead wire (13) between a mechanical
lifting upward.
deck (14) and FCB unit (6) by loosening screw (15).
2. Remove left and right insulators. Insulators (A) can be
Note:
remove by unfastening the hook of the chassis
inserting a bar into the hole (B) located on the bottom,
and by sliding it to the arrow mark direction.
In this case, remove FFC (7) on KDB unit (5) side, lead
wire (9) on FCB unit (6) side and lead wire (13) on
mechanical deck (14) side.
5. Remove two screws (17) and power unit (16).
6. Remove a screw (18) securing the mechanical deck
(14).
(2) Screw
(1) Top Cover
(15) Screw
es,
(13) Lead wire —~ '¥
(19) Top bracket
(20) Terminal board
(17) Screws
(12) Terminal unit
——
(16) Powerunit
(8) Main unit
(7) FFC
(22) Screw
(21) Reel belt
(11) Lerd wire
(10) Lead wire
(9) Lead wire
(6) FCB
(18) Screw
(5) KDBU nit
(4) Connector
Fig. 5-1-2
Werbung
