Werbung
1-6-8. Arm Brake Lever Assembly and
Arm Brake Torsion Spring Replacement
1. Make the cassette holder assembly to the slot-out
(EJECT) position.
2. Turn the arm brake lever assembly (1) in the direction
shown by the arrow (A) until it stops. Pull out the arm
brake lever assembly (1) to the front at the position it
stops.
Note:
Take care that the arm brake torsion spring (2) is removed
forcefully.
Groove on the
Arm brake
mechanical deck
torsion spring (2)
Arm brake lever
assembly (1)
Fig. 6-8-1
3. Hook the arm brake torsion spring (2) temporarily to a
new arm brake lever assembly (1).
Note:
Take care of the direction of the arm brake torsion spring
(2) so that the longer end of the arm brake torsion spring
(2) is hooked on the temporary hook.
Cs
fl)
Se,
Arm brake lever
assembly (1)
Temporary hook
Arm brake torsion
spring (2)
Fig. 6-8-2
2-13
. Insert the hook portion on the arm brake lever
assembly (1) to the cutout on the mechanical deck.
. Turn the arm brake lever assembly (1) counterclock-
wise and fix it at the position which the arm brake
lever assembly (1) faces to the straight below.
. When pushing the tip of the arm brake torsion spring
(2) located at (B) position, the tip is removed from the
temporary hook and moves to the hook on the
mechanical deck.
. The arm brake lever assembly turns to the specified
position by force of the arm brake torsion spring.
=
Arm brake
Arm brake lever
torsion spring (2)
assembly (1)
Groove on the mechanical deck assembly
Fig. 6-8-3
Werbung
