Werbung
5-1. Precautions for Part Replacement
*
In the schematic diagram, parts marked A\
(ex. A\ F801) are critical part to meet the safety regulations, so always use
the parts bearing specified part codes (SN) when replacing them.
*
Using the parts other then those specified shall violate the regulations, and may cause troubles such as operation
failures, fire, etc.
5-2. Solid Resistor Indication
W\-
Tolerance
*+5%
es
eae
++ 0.25 %
-£0.5 %
=
ae
++2%
++10%
Rated Wattage
Type
Tolerance
+++20%
Rated Wattage
(1) Chip Parts
None+ ++ 1/16 W
(2) Other Parts
None+ ++ 1/6 W
Other then above, described in the Circuit Diagram
+ + «Carbon film
«+ «Solid
+ + «Oxide metal film
+ + »Metal film
+ + «Cement
+ » «Fusible
5-3. Capacitance Indication
+ + + Electrolytic. Special electrolytic
| |
+ + + Non polarity electrolytic
C] 100) a []
+ + » Ceramic, plastic
J
f
\
+++ Film
Temparature Rated
Toeranc
response
Voltage
+ «+ Trimmer
Rated voltage
For other than 50 V and electrolytic capacitors.
described in the Circuit Diagram.
Tolerance
(1) Ceramic, plastic, and film capacitors of which
capacitance are more than 10 pF.
None
+ + ++5 % or more
B
++ +t0.1%
Cc
+ ++ 0.25 %
D
+2 +t05 %
F
G
ooet1%
22 et 2%
(2) Ceramic, plastic, and film capacitors of which
capacitance are 10 pF or less.
None + + +more than + 5 pF
B
++ +t0.1 pF
Cc
++ ++0.25 pF
(3) Electrolytic. Trimmer
Tolerance is not described.
Temperature characteristic
None + --SL
(Ceramic capacitor)
For others, temperature characteristics are described.
(For capacitors of 0.01 mF and no indications are
described as F.)
Werbung
