Werbung
Note:
The grip lever (4) on the cassette holder assembly (1) may
catch the trapezoidal cam on the mechanical deck (2), so
perform the work lifting the grip lever in the direction
shown by the arrow.
Cassette holder
assembly (1)
Mechanical
deck (2)
Fig. 6-2-2
4. After removing the front side bosses (5) on both left
and right sides, remove the cassette holder assembly
(1) pulling to the front side.
5. When mounting the cassette holder assembly (1),
insert the front side bosses (5) to the U shaped groove
of the drive arm (6) and the guide groove (2) on the
mechanical deck lifting the rear side of the cassette
holder assembly (1).
Front side
boss (5)
Guide groove (2)
Cassette holder
assembly (1)
Front side boss (5)
Drive arm (6)
2-10
6. When mounting the rear side bosses (3), perform the
reverse order of removal.
1-6-3. Door Open Lever Replacement
1. Release the lock lever (2) on the cassette holder
assembly (1) pressing in the direction shown by the
arrow.
Lock lever (2)
Lock lever (2)
Cassette holder assembly (1)
Fig. 6-3-1
2. Move the cassette holder assembly (1) slightly to the
rear side.
3. Remove the claws (A) and (B) on the door open lever
(3) from the mechanical deck (4).
4, Match the boss on a new door open lever (3) and the
hole (C) on the mechanical deck, and then insert the
claws (B) first and then (A) to the mechan ical deck
(4).
Door open
lever (3)
Mechanical deck (4)
Y
Hole (C)
Claw (B)
Fig. 6-3-2
5. Remount the cassette holder assembly to the position
as it was.
Werbung
