Werbung
3. Turn over the mechanical deck.
2. Remove the cassette holder assembly. (Refer to item
4. Remove the stop ring (1).
"1-6-2. Cassette Holder Replacement".)
slider assembly (2) as a fulcrum.
4. Remove the tension spring (1).
6. Mount the parts in the reverse order of removal.
5. Turn the hook lever assembly (2) couriterclockwise
slightly, and remove the claw on the hook lever
Note:
assembly (2) then replace.
* When mounting the loading slider assembly (2), insert
6. After replacing the hook lever assembly (2) , insert the
the tip of the loading slider assembly (2) slightly to the
(A) portion of the hook lever under the S reel table
mold portion, then mount it so that the claw on the
assembly. When the portions (B), (C), (D) are in line,
loading slider assembly.
Confirm that the position mark on the loading slider
Tension spring (1)
assembly (2) and the mark on the T loading gear
match each other in position.
S ree! table
assembly
assembly (2)
Cam slider
we
;
a
Fig. 6-26-1
Capstan
Cutout
Cylinder
the direction shown by the arrow, and then position
f
id
;
Mechanisn
eke
the boss (E) under the cam slider.
T loading gear
S reel table
assembly
Marking
Mark
Fr
2
:
Cam slider
j
Loading slider assembly (2)
Fig. 6-25-2
Fig. 6-26-2
2-23
Werbung
