Werbung
1-6-41. Cam Slider Replacement
1. Remove the top bracket and the cassette holder
assembly. (Refer to item "1-6-1. Top Bracket Replace-
ment and 1-6-2. Cassette Holder Assembly Replace-
ment"'.)
2. Remove the tension spring (1).
3. Turn the hook lever assembly (2) counterclockwise
and turn the S soft brake (3) counterclockwise.
4. Move the cam slider (4) to the right and align the
projection (A) on the mechanical deck and the cutout
portion (B) on the cam slider (4).
5. Remove the claw (C) on the cam slider (4) and
remove the cam slider (4) lifting the cam slider (4)
upward.
Hook lever assembly (2)
S soft brake (3)
Cam slider (4)
Claw (C)
Cutout (B)
Tension spring (1)
Fig. 6-41-1
6. Apply grease on the shaded portion of a new slider for
the replacement.
7.
Mount the parts in the reverse order of removal. After
inserting the cam slider, slide it to the left direction till
it stops. (Fig. 6-26-2 shows this condition.)
Note:
*
When mounting the cam slider (4), slide the tension
drive lever in the direction shown by the arrow
(counterclockwise).
¢
After completion of the replacement, confirm that the
cam slider (4) can slide to left and right directions
smoothly.
Apply grease
Apply grease
( inside Claw (C) )
Cam slider top side
Apply grease.
Apply grease.
Apply grease.
Cam slider bottom side
Fig. 6-41-2
1-6-42. Idle Centering Lever Replacement
1. Remove the cam slider. (Refer to item "1-6-41. Cam
Slider Replacement".)
2. Remove the claw on the idle centering lever (1) and
remove the idle centering lever (1) lifting it upward.
3. After replacing the idle centering lever (1), mount the
part in the reverse order of removal.
Idle centering
lever (1)
Idle arm
assembly
Fig. 6-42-1
Werbung
