Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Interval
Where?
Start of work,
after every main-
tenance or repair
work
Start of work,
after every main-
tenance or repair
work
Every week
Monthly
Monthly
When necessary
When necessary
EN
MH50G│MH50V
96
What?
How?
Safety check on page 69
Oil all guide rails.
Oiling
Oil all bare steel surfaces. Use acid-free oil.
Oiling
Ensure that the clamping bolts for swivelling the drill head
are firmly tightened.
firmly tight-
ened
Lubricate all oiler cups with machine oil, do not use grease
guns or the like.
Oiling
An larger amount of backlash in the milling head spindle can
be reduced by adjusting the spindle nut. The spindle nuts are
reset by reducing the thread flanks of the spindle nut with two
readjust
take-up screws. After the reset, it is necessary to check if there
Z axis
is still smooth movement over the entire path, otherwise wear
is considerably increased due to friction between the spindle
nut and the spindle.
Turn the take-up screws of the gib clockwise. The gib is
pushed further inward thus reducing the play in the guide
readjust
rail.
Z axis
Check the settings. The corresponding guide rail must be
more easily movable but ensure stable guidance.
Translation of original instruction
Version 1.0.5 - 2021-01-29
Werbung
