Optimum 3338180 Betriebsanleitung Seite 70

1.11 Personal protective equipment
For certain work, personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12 For your own safety during operation
WARNING!
Before switching the milling machine on, make sure that there is no risk of personal
injury or damage to property.
Avoid any unsafe work methods:
Make sure that your operation does not create a safety hazard.
The rules specified in these operating instructions must be observed during assembly,

operation, maintenance and repair.
Use protective glasses!

Switch off the milling machine before measuring the workpiece.

Do not work on the milling machine, if your concentration is reduced, for example, because

you are taking medication.
Stay at the milling machine until the movements have stopped completely.

Use the specified personal protective equipment. Ensure you wear close-fitting clothing

and, if necessary, a hairnet.
Do not use protective gloves when drilling or milling.

Turn off the machine before changing the milling tool.

Use appropriate agents to remove drilling and milling chips.

Ensure that your work does not create a safety risk.

Clamp the workpiece securely and firmly before switching on the milling machine.

We specifically point out the dangers in the description of work with and on the drilling machine.
1.13 Switching-off and securing the milling machine
1.13.1 Lockable main switch
WARNING!
Dangerous voltage even if the main switch is switched off.
The areas marked by the pictogram might contain live parts, even if the master switch is
switched off.
In the "0" position, the lockable main switch can be secured against accidental or non-author-
ised switching on by means of a padlock.
The power supply is cut off when the master switch is in the off position.
EN
MH50G│MH50V
70 Translation of original instruction Version 1.0.5 - 2021-01-29