Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
a long working life of the milling machine and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
extremely serious injuries to those working on the milling machine and
damage to the milling machine.
Maintenance and repair work on the milling machine must be carried out by qualified
technical personnel only.
5.1.1
Preparation
WARNING!
Only work on the milling machine if it has been disconnected from the power supply.
Switching-off and securing the milling machine on page 70
Attach a warning sign.
5.1.2
Restarting
Before restarting, run a safety check.
Safety check on page 69
WARNING!
Before starting the milling machine, it is essential that you ensure that this does not
constitute a risk to personal safety or damage to the milling machine.
5.2
Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Version 1.0.5 - 2021-01-29
Translation of original instruction
MH50G│MH50V
EN
95
Werbung
