Optimum 3338180 Betriebsanleitung Seite 94

4.15 Swivelling the milling head
The milling head can be swivelled to the right and to the left.

Loosen 2 fastening screws on the milling head.

Turn the drill-mill head clockwise to the desired position.

Retighten the fastening screws.
INFORMATION
The milling head should be aligned after resetting to the initial position with a dial indicator so
that holes can be produced with the spindle sleeve at a right angle. Set the zero degree angle
step using your set-up.
ATTENTION!
The drill-mill continues significantly further and also swivels in a different direction. By
continuing to swivel, gear oil may seep from the ventilation hole.
EN
MH50G│MH50V
94
A
Zero degree angle step
Translation of original instruction
B
Version 1.0.5 - 2021-01-29