Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2
Unpacking the machine
Install the machine close to its final position before unpacking. If the packaging shows signs of
having possibly been damaged during transport, take the appropriate precautions to prevent
the machine being damaged when unpacking. If damage is discovered, the carrier and/or ship-
per must be notified immediately so the necessary steps can be taken to register a complaint.
Examine the complete machine carefully and check whether all materials, such as shipping
documents, instructions and accessories have been delivered with the machine.
3.3
Installation and assembly
3.3.1
Installation site requirements
The power plug of the milling machine must be readily accessible.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights (available as
an option) must be used.
In order to achieve sufficient safety against falls by slipping, the accessible area in the mechani-
cal machining zone of the machine must be equipped with a slip resistance. The slip-resistant
mat and/or slip-resistant flooring must be at least R11 in accordance with BGR 181.
The used shoes must be suitable for being used in those machining areas. The accessible sur-
faces must be cleaned.
Organize the working area around the milling machine according to the local safety regulations.
The work area for operation, maintenance and repair must not be restricted.
3.3.2
Load suspension point
WARNING!
Danger of crushing and overturning. Proceed carefully when
lifting, installing and assembling the machine.
Fix the load lifting gear around the drilling-milling head. Use a
lifting sling for this purpose.
Lock all clamping levers on the drilling-milling machine before
you lift it.
Make sure that no add-on pieces or varnished parts are dam-
aged due to the load suspension.
Take care with the centre of gravity of the machine.
Dimensions, balance point on page 79
3.3.3
Assembly
Check that the milling machine foundation is horizontal with a spirit level.
Check that the foundation has sufficient load-bearing capacity and rigidity.
ATTENTION!
Inadequate rigidity of the foundation will cause interaction of vibrations between the
milling machine and the foundation (resonant frequency of the components). If the
Version 1.0.5 - 2021-01-29
Translation of original instruction
MH50G│MH50V
EN
77
Werbung
