Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.2
Safety
The milling machine must only be operated under the following conditions:
The milling machine is in proper working order.
The milling machine is used as intended.
The operating instructions are followed.
All safety devices are installed and activated.
Eliminate or have all malfunctions rectified promptly. Stop the milling machine immediately in
the event of any abnormality in operation and make sure it cannot be started up accidentally or
without authorisation.
For your own safety during operation on page 70
4.3
Switching the milling machine on
Switch on the master switch.
Unlock the emergency stop button.
Set and close the spindle protection.
INFORMATION
The machine cannot be started, if the spindle protection is not closed and the locking pin of
integrated drill drift is in drifting position.
For MH50G machines with integrated control:
In the event of an overload, the control unit protects the drive motor. The overload LED on the
integrated control unit in the control cabinet next to the red reset button lights up yellow.
Press the red reset button to reset the overload and check the cause of the overload.
4.4
Switching the milling machine off
Switch off the master switch.
Switching-off and securing the milling machine on page 70
CAUTION!
Only press the emergency-stop button in a genuine emergency. You should not use the
emergency-stop button to stop the machine during normal operation.
4.5
Resetting an emergency stop situation
Unlock the emergency stop switch again.
Switch on the spindle rotation again.
4.6
Power failure, Restoring readiness for operation
Switch on the spindle rotation again.
4.7
Speed setting
A speed change at the MH50G is done by inserting of gear stages and stage selection of the
drive motor.
A speed change at the MH50V is continuously adjustable within the gear stage engaged with
the rotary knob on the control panel.
EN
MH50G│MH50V
88
Translation of original instruction
Version 1.0.5 - 2021-01-29
Werbung
