Optimum 3338180 Betriebsanleitung Seite 59

1 Safety
Glossary of symbols
provides further instructions


calls on you to act
listings

This part of the operating instructions
explains the meaning and use of the warning notes included in these operating instructions,

defines the intended use of the milling machine,

points out the dangers that might arise for you or others if these instructions are not

observed,
informs you about how to avoid dangers.

In addition to these operation instructions, please observe
the applicable laws and regulations,

the statutory provisions for accident prevention,

the prohibition, warning and mandatory signs as well as the warning notes on the milling

machine.
When installing, operating, maintaining and repairing the milling machine, the relevant stand-
ards must be observed.
If European standards have not yet been incorporated in the national legislation of the country
in question, the specific applicable regulations of each country must be observed.
If necessary, relevant measures must be taken to comply with national regulations before com-
missioning the milling machine.
Always keep this documentation close to the milling machine.
If you want to re-order the operating instructions for your machine, please quote the relevant
serial number. The serial number can be found on the type plate.
1.1 Rating plates
Version 1.0.5 - 2021-01-29 Translation of original instruction
MH50G│MH50V EN
59