Before Commissioning - Scheppach TBD55 Originalbetriebsanleitung

Sound pressure level L
Uncertainty K
pA
Sound power level L
Uncertainty K
WA
Wear ear-muffs.
Excessive noise can result in a loss of hearing.
The above-mentioned noise emission values were measured in accor-
dance with a standardised test procedure and can be used to compare
one power tool with another.
The specified device emissions values can also be used for an initial
estimation of the load.
Warning:
• The noise emission values can vary from the specified values during
the actual use of the electric tool, depending on the type and the man-
ner in which the electric tool is used, and in particular the type of work-
piece being processed.
• Try to keep the stress as low as possible. For example: Limit working
time. In doing so, all parts of the operating cycle must be taken into ac-
count (such as times in which the electric tool is switched off or times
in which it is switched on, but is not running under a load).

8. Before commissioning

• Open the packaging and carefully remove the device.
• Remove the packaging material as well as the packaging and trans-
port bracing (if available).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport damage.
• If possible, keep the packaging until the expiry of the warranty period.
m ATTENTION
The device and the packaging are not children's toys! Do not let
children play with plastic bags, films or small parts!
pA
WA
www.scheppach.com
89,6 dB(A)
3 dB
102,6 dB(A)
3 dB
GB | 49