Herunterladen Inhalt Inhalt Diese Seite drucken

Transport; Cleaning And Maintenance - Scheppach TBD55 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Once the electric tool is connected to the power supply again it
will start up with a preset speed of 1500 rpm.
10.10 Drilling procedure (fig. 1)
1. Align the workpiece and clamp it firmly in place as described in point
10.6.
2. Start the device and set the speed, as described in point 10.8.
3. For drilling, move the handle (8) with uniform feed until the desired
drilling depth is reached. When drilling into metal, interrupt the down-
ward pressure briefly to break the swarf.
4. After reaching the drilling depth, return the handle (8) to the starting
position.
5. Switch the device off.

11. Transport

• To transport the device hold it by the base plate (1).

12. Cleaning and maintenance

m Warning! Pull out the mains plug before carrying out any adjust-
ments, maintenance or repair work!
11. 1 General maintenance tasks
Wipe swarf and dust off the machine from time to time with a cloth. Oil
the rotating parts once monthly to extend the life of the tool. Do not oil
the motor.
Do not use corrosive agents for cleaning the plastic.
m Have tasks that are not described in this operating manual, car-
ried out by a specialist workshop. Use only original parts. Let the
device cool down before all maintenance and cleaning tasks.
m There is a risk of burn!
www.scheppach.com
GB | 55

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

5806805986

Inhaltsverzeichnis