Warning! With workpieces that are wider or longer than the tabletop,
ensure that these are adequately supported, e.g. through trestles or saw
horses.
Workpieces that are longer or wider than the base plate of the tabletop
drill can tip if they are not properly supported. If the workpiece tips, this
can damage the chuck guard or the cutting tool.
10.8 Setting the drilling speed (fig. 4)
The correct speed must be set to suit the workpiece to be drilled and the
tool diameter.
10.8.1 Electronic speed control:
The speed of the individual gears can be seamlessly adjusted with the
electronic speed control:
Set the speed with the help of the speed control (12.1/12.2).
The current speed can be seen on the display (9).
10.9 Switching on/off (fig. 1)
m Make sure that the chuck guard (13) is folded down before
switching on.
Switching on: Press the on switch (11) to switch the device on.
Switching off: Press the off switch (10) to switch the device off.
m Attention: The speed set during the drilling process will be sa-
ved and will be kept until changed or the electric tool is disconnec-
ted from the mains.
54 | GB
www.scheppach.com