Scheppach TBD55 Originalbetriebsanleitung Seite 52

4. Secure the position of the machine head with the height adjustment
clamping lever (5).
Attention! Ensure in the lowest machine head position that the machine
head will not be moved beyond the marking.
Use the clamping lever for height adjustment (5) to secure the machine
head in this position. Otherwise, the guide could be damaged.
10.3 Setting the drilling depth (fig. 1, 11)
The drilling depth can be set with the depth stop (7).
1. Release the clamping lever on the depth stop (6).
2. Carry out a test drilling. As soon as the desired depth, tighten the
depth stop clamping lever (6) again.
3. The depth stop (7) is now locked in the desired drilling depth.
4. Then check the position of the angle display. If necessary, loosen the
pointer (18) with a Phillips screwdriver, set the scale (20) to 0° position
and re-tighten the retaining screw (19).
10.4 Clamping/releasing drill bits (fig. 4, 7)
Caution! Always release the chuck key. Risk of injury due to
chuck key being thrown away!
10.4.1 Clamping
1. Fold the tension chuck guard (13) upwards.
2. Insert the chuck key (G).
3. Turn the chuck key (G) counterclockwise, to open the clamping sleeve
(E).
4. Insert the insertion tool (F).
5. Hold the insertion tool (F) firmly.
6. Turn the chuck key (G) clockwise, to close the clamping sleeve (E) and
to secure the insertion tool.
7. Check that the insertion tool (F) is tightly fitted.
8. Pull the chuck key (G) apart.
52 | GB
www.scheppach.com