Troubleshooting; Reset Error Messages - Rob 5000; Reset Error Messages - Rob 4000; Displayed Service Codes - Fronius ROB 4000 TIG Bedienungsanleitung

Troubleshooting

Reset error Error messages on the power source are reset using the "Source error reset" signal (not
messages - ROB illustrated on this page). However, the cause of the error must first be eliminated.
5000
Danger from surprisingly starting welding process.
This can result in serious injury and damage to property.
▶
▶
▶
▶
Reset error In contrast to the ROB 5000/ROB 5000 OC, the ROB 4000 robot interface does not allow
messages - ROB errors to be reset using the „Source error reset" signal. Error messages on the power
4000 source are reset automatically as soon as the error is rectified.
Danger from surprisingly starting welding process.
This can result in serious injury and damage to property.
▶
Displayed service A detailed description of the Service Codes that can be displayed can be found in
codes the "Troubleshooting" chapter of your power source operating instructions.
WARNING!
If the "Source error reset" signal is still
24 V ROB 4000/5000 (High)
GND ROB 5000 OC (Low),
the „Welding start" signal must not be set while the error is being rectified, otherwise
welding will start as soon as the error is fixed.
WARNING!
"Welding start" signal must not be set while the error is being rectified, otherwise
welding will start as soon as the error is fixed.
73