CGS XT-T1 Betriebsanleitung Seite 162

E
Right
avoid crushing the line by a crushprotector.
crush-protector with the minimal bending
Product:
Temperature controller XT-T1
If the line is used an a portable unit,
If you have to bend the line use a
radius.
By calculating the length of the line,
think about a straight mounting of the
ends which needs additional length
(app. 5x line diameter).
The line should not sag somewhere in
the mounting. Use a duct or a support.
Revision 2.0 – Issue September 2018
Wrong
162/166