CGS XT-T1 Betriebsanleitung Seite 111

Category
Digital control signals
Ext. digital inputs
Flags
Logic
ST digital outputs
ST alarm/error
Service
Operation
9.3 System data
The general system data is configured in this menu.
Parameter
Device name
(setup only)
National language
Language selection ac tive
Temperature unit
Product:
Temperature controller XT-T1
Signal
Digital control signal 1 to
digital control signal 4
Ext. digital input 1
ext. digital input 2
Digital flags 1
digital flags 2
Logic result 1 to
logic result 4
ST digital output 1 to
ST digital output 4
ST alarm
ST error
Service signal
Short-press back button
(< 2 s)
Long-press back button
(> 2 s)
Selection/text/value
Name
(editable)
German
English
French
Spanish
No
Yes
°C
°F
Revision 2.0 – Issue September 2018
Description
Output signals of the respective function (confi gurable)
Signal of the external digital inputs 1 and 2 (via in-
terface)
Digital flags are binary values that can be de scribed and
read out as well as internally pro cessed via the interface.
Results of the logic formulae (formula 1 to formula 4)
Signals of the digital outputs from the PLC module (appli-
cation created with ST code)
Alarm signal from the PLC module (application created
with ST code)
Error signal from the PLC module (application cre ated
with ST code)
The signal is activated if the service counter has reached
the set limit value and remains active until acknowledge-
ment.
The signal is active (for the duration of a sampling peri-
od) after briefly pressing the „Back" button.
The signal is active (for the duration of a sampling peri-
od) after long-pressing the „Back" button.
Description
Device designation (in the „Device information" menu)
National language of display texts
Language selection after switching on the next time
If „Yes", the user can select the national language for the
device texts after the next time the device is switched on
- following the change to the configu ration.
After applying the national language, this parame ter is
automatically set to „No", so that language selection is
not necessary the next time the device is switched on.
Temperature unit for the display on the device and in the
setup program (automatic conversion from °C to °F)
E
111/166