CGS XT-T1 Betriebsanleitung Seite 113

Parameter
Running speed
Short-press back button
(< 2 s)
Long-press back button
(> 2 s)
Start delay time
Key lock
Display off
Additional functions
(setup only)
Level inhibit
The level inhibit can be adjusted on the device using a key combination.
ð chapter 7.6 „Level inhibit"
Display texts (setup only)
Up to 10 display texts can be entered in the setup program (Configuration level > Display/operation > Display texts). The-
se can be selected through the corresponding programming using an ST code so that they are displayed on the device.
Parameter
Display text 1
to
Display text 10
In addition, there are two other texts available that are displayed on the device - regardless of the ST code. The display
is controlled by a digital signal. This way, an alarm text can, for example, be displayed in a simple way if a limit value is
exceeded. To do so, the signal of the limit value monitoring function must be used to control the text display.
Parameter
Message text 1
Product:
Temperature controller XT-T1
Selection/text/value
1 to 3 (2)
Without function
Manual mode
Start autotuning
Display timer value
Manual mode
(See above for other func-
tions)
0 to 300 s
Digital selector
No selection
Digital selector
No selection
Expansion 1 to
Expansion 5
Selection/text/value
<Enter text>
ST text 0
to
ST text 9
Selection/text/value
<Enter text>
Message text 0
Revision 2.0 – Issue September 2018
Description
Running speed of the display text
Function of the „Back" button when short-pressing the
button (less than two seconds)
Additional functions of the button can be selected in the
configuration of the individual device func tions (digital
selector).
Function of the „Back" button when long-pressing the
button (more than two seconds)
Start delay time (in seconds) after Power ON
All functions of the device are only active after this time
has elapsed.
Digital signal (high active) for inhibiting the buttons
Digital signal (high active) for switching off all dis plays
Reserved functions for service purposes. Only ac tivate
when instructed to do so by service person nel!
Click checkbox to activate the function.
Description
The text to be output must be selected in the ST code via
text index 1 to 10 (0 = do not output text). The line where
the text is to be displayed must also be specified here.
Description
Formats 108H, 108Q, and 104:
The text is displayed in line 3.
Formats 132 and 116:
Without function
E
113/166