CGS XT-T1 Betriebsanleitung Seite 102

Operating level
Configuration
E
Device information
Example for changing a configuration parameter
Changing the linearization of the analog input.
1. Press the „Menu/OK" button to move from the basic status to the main menu (menu).
2. Press the „Down" (or „Up") button repeatedly until the „Configuration" menu item appears.
3. Press the „Menu/OK" button to move to the „Configuration" sub-menu.
4. Press the „Down" (or „Up") button repeatedly until the „Analog input" menu item appears.
5. Press the „Menu/OK" button to move from to the analog input's configuration menu.
6. Press the „Down" (or „Up") button repeatedly until the „Linearization" menu item appears.
7. Press the „Menu/OK" button to switch to editing mode.
The current value „Pt100" flashes (default setting for „RTD temperature probe" signal type).
8. Change the current value using the „Down" (or „Up") button until the new value „Pt1000" flashes.
9. Press the „Menu/OK" button to apply the new value and to exit editing mode (if „Auto save" = No).
Successful application of the new value is confirmed by „OK" being displayed.
10. Press the „Back" button several times to return to the basic status.
7.6 Level inhibit
Access to the individual levels can be inhibited. Press and hold the „Menu/OK" and „Down" buttons at
the same time for longer than 5 seconds to set the level inhibit.
The corresponding degree of inhibition can be selected using the „Up" and „Down" buttons and confirmed
using the „Menu/OK" button.
Inhibited levels
None (all levels free; default setting)
Sub-menu 1
System data
Display / Operation
Analog input
Digital inputs
Analog output
(if available)
Digital outputs
Controller
Programm controller
Timer
Limit value monitoring functions
Serial interface
(if available)
Versions
Service
Product:
Temperature controller XT-T1
Sub-menu 2
Controller configuration
Controller input
Autotuning
Setpoint values
Ramp function
1. Grenzwertüberwachung
...
4. Grenzwertüberwachung
Revision 2.0 – Issue September 2018
102/166