CGS XT-T1 Betriebsanleitung Seite 142

Parameter
Decimal places
E
ST editor
Press the corresponding button to start the ST editor.
.
NOTE!
There is a separate manual for the ST editor available with further information.
10.2 Digital control signals
The device provides the option to individually configure up to four digital control signals. The following con-
figuration parameters are available for each of the four control signals.
Parameter
Digital signal
Function
Signal 2
Signal 3
Inversion
Selection/text/value
Auto
XXXX.
XXX.X
XX.XX
X.XXX
Selection/text/value
Digital selector
No selection
Without function
Impulse
Delay
Pulse function
Rising edge
Falling edge
OR function
AND function
XOR function
Digital selector
No selection
Digital selector
No selection
No
Yes
Product:
Temperature controller XT-T1
Description
Number of pre-decimal and decimal places for the nume-
rical display of the value
Automatic
No decimal place
One decimal place
Two decimal places
Three decimal places
Description
Input signal (or OR/AND/XOR signal 1)
The output signal corresponds to the input signal (with
inverting if necessary).
A pulse-like signal is output as long as the input signal is
active (high).
The output signal follows the course of the input signal,
whereby the transfer from low to high status and vice ver-
sa is delayed.
The output signal is activated for the duration of the pulse
time for the rising edge of the input sig nal.
The output signal is activated for the duration of a cycle
interval for the rising edge of the input signal.
The output signal is activated for the duration of a cycle
interval for the falling edge of the input signal.
Logical OR link of the input signals (signal 1, signal 2, si-
gnal 3)
Logical AND link
Logical XOR link
Second input signal for the logical link
Third input signal for the logical link
Output signal (control signal) not inverted
Output signal (control signal) inverted
Revision 2.0 – Issue September 2018
142/166