CGS XT-T1 Betriebsanleitung Seite 100

7.2 Language selection
After switching on the device for the first time, the user can either confirm the flashing displayed language
with „OK" or select another language using the „Up"/"Down" buttons and then confirm this with
E
„OK".
If, at a later point, another user is to also have the option of selecting a language, the configuration parameter
„Language selection active" must be set to „Yes" (Configuration > System data). After applying
the language, this parameter is automatically set to „No", so that language selection is not necessary the
next time the device is switched on.
The language of the device texts can be changed at any time in the configuration settings (regardless of
language selection after switch-on).
7.3 Basic status
The following displays and functions are supported in the basic status.
Displays
The values for the analog signals are shown in the displays as a function of the configuration (Configuration
> Display/operation).
Default setting:
• Display 1 (top 18-segment display): Analog input
• Display 2 (bottom 18-segment display): Current setpoint value
• Display 3 (top line of the pixel matrix display, only for types 702112 (format 108H), 702113 (108Q),
702114 (104)): No display
• Display 4 (bottom line of the pixel matrix display, only for types 702112, 702113, 702114): No display
Setpoint value
The setpoint value can be adjusted directly using the „Up" and „Down" buttons.
Timer mode
The „Display change upon timer start" function (Configuration > Display/operation) has the effect that,
once the timer is started („Timer" symbol flashing), the timer's runtime or the remaining time is shown on
the bottom display.
In order to show the timer value (set time), the „Back" button can be configured accordingly (Configuration
> Display/operation).
Manual mode
With the corresponding configuration (Configuration > Display/operation), the „Back" button can be used
to switch to manual mode (default setting: press key for more than 2 seconds).
The „Manual mode" symbol is illuminated during manual mode.
Autotuning
Autotuning is started by long-pressing (> 2 s) the „Up" and „Down" buttons at the same time.
The text „Autotuning" is displayed whilst autotuning is running.
Message texts
A configurable message text can be shown on both the top and bottom display. The text display is controlled
by a digital signal. The „ST code" option (extra code) gives the user the option to select up to 10 additional configurable
display texts (Configuration > Display/operation > Display texts).
Product:
Temperature controller XT-T1 Revision 2.0 – Issue September 2018
100/166