CGS XT-T1 Betriebsanleitung Seite 115

Parameter
Linearization
Temperature
Unit
(setup only)
Resistance measuring range 0...400 Ω
Resistance Ra or R0
?
Resistance Rs or Rx
?
Resistance Re
?
Product:
Temperature controller XT-T1
Selection/text/value
Pt100
GOST Pt100
Pt1000
KTY two-wire
L / Fe_CuNi
J / Fe_CuNi
U / Cu-CuNi
T / Cu-CuNi
K / NiCr-Ni
E / NiCr-CuNi
N / NiCrSi-NiSi
S / Pt10Rh-Pt
R / Pt13Rh-Pt
B / Pt30Rh-Pt6Rh
C / W5Re-W26Re
D / W3Re-W25Re
A1 / W5Re-W20Re
L / Chromel®-Copel®
Chromel®-Alumel®
Linear
Customer-specific
None
Relative
Absolute
<Enter text>
%
0...4000 Ω
0 to 4000 (Ω)
0 to 4000 (1000) (Ω)
0 to 4000 (Ω)
Revision 2.0 – Issue September 2018
Description
Only with RTD temperature probe
Only with thermocouple
Only with resistance/potentiometer, resistance transmit-
ter, voltage, current
Customer-specific linearization with 4th order poly nomial
or grid points (configurable with setup pro gram)
Only with resistance/potentiometer, resistance transmit-
ter, voltage, current:
This selection is important for the automatic con version
in case of a change in temperature unit (°C/°F) (see
system data).
The value is not a temperature.
The value is a temperature difference.
The value is a temperature value.
Value unit (if it is not a temperature)
Measuring range for resistance/potentiometer and RTD
temperature probe with customer-specific lin earization
For resistance transmitter: Resistance Ra between slider
(S) and start (A), if the slider is positioned at the start.
For resistance/potentiometer: Offset resistance Ro
For resistance transmitter: Resistance range Rs of the
slider
For resistance/potentiometer: Shifting resistance range
Rx
For resistance transmitter: Resistance Re between slider
(S) and end (E), if the slider is positioned at the end.
E
115/166