CGS XT-T1 Betriebsanleitung Seite 161

19 Appendix D
(Mounting instructions heated line)
Minimal bending radius: 300 mm
Right
Product:
Temperature controller XT-T1
The heated sample line are normally
coiled up after delivery.
It is important that the line will be
coiled off and not be crushed.
This will damage the lines.
The line should not be moved
while mounted straight. For this
use a U-like mounting.
The axis's of the lines should be
parallel, therefore the levels of
movement are in the same.
Revision 2.0 – Issue September 2018
E
Wrong
161/166