CGS XT-T1 Betriebsanleitung Seite 109

9.2 Selectors
The selectors contain signals that are available for configuration on the device or in the setup program. These are device
signals (e.g., analog and digital inputs or internal signals), and signals that are trans ferred to the device via Modbus
(external analog and digital inputs, analog and digital flags).
Analog selector
Category
No selection
Analog input
Controller
Setpoint values
Program setpoints
Program
Ramp
Timer
Ext. analog inputs
Flags
Math result
Product:
Temperature controller XT-T1
Signal
Analog input
Actual value
Setpoint value
Sampling rate
Controller output 1 (ana log) Switched controller output 1 (0 to +100 %; e.g., for hea-
Controller output 2 (ana log) Switched controller output 2 (-100 to 0 %; e.g., for coo-
Controller differential
Output level display
Setpoint 1 to
setpoint 4
Current setpoint value
Program setpoint value
Section end value
Section remaining run ning
time
Program remaining run ning
time
Section runtime
Program runtime
Ramp end value
Current ramp setpoint value Current value of the setpoint ramp
Timer runtime
Timer remaining running
time
Timer value
Ext. analog input 1
ext. analog input 2
Analog flag 1
analog flag 2
Math result 1 to
math result 4
Revision 2.0 – Issue September 2018
Description
No signal selected
Analog input signal
Actual value on the controller input
Active setpoint value on the controller input
Sampling rate (fixed value: 150 ms)
ting)
ling)
Difference between setpoint value and actual val ue of
the controller
Controller output level (-100 % to +100 %)
Setpoint values that can be selected through the setpoint
changeover.
Setpoint value selected through the setpoint changeover
Current program setpoint
Setpoint value at the end of the program section
Remaining running time of the current program section
in seconds (remaining time)
Remaining running time of the program in seconds
(remaining time)
Runtime of the current program section in seconds (al-
ready elapsed time)
Runtime of the program in seconds (already elapsed
time)
End value of the setpoint ramp (corresponds to the speci-
fied setpoint value)
Runtime of the timer in seconds (already elapsed time)
Remaining running time of the timer in seconds (remai-
ning time)
Set timer time in seconds
Signal of the external analog inputs 1 and 2 (via in-
terface)
Analog flags are analog values that can be de scribed and
read out as well as internally pro cessed via the interface.
Results of the math formulae (formula 1 to formula 4)
E
109 /166