Configuring the Water Management Server
Configuring hygiene functions
Configuring flow time
Overview of parameters:
Flow time
Please note:
Fittings are out of operation for the set period of time after the
Configuring the activation signal
Overview of configurable parameters:
Activation signal
Please note:
An external activation signal can be set for the cleaning stop. The time frame
for the cleaning stop will depend on the activation signal used:
– Activation via a button -> the set flow time expires and the fitting is then
reactivated
– Activation via a software button (manual operation) -> the set flow time
expires and the fitting is then reactivated
– Activation via a switch -> the fitting is out of operation while the switch
remains activated (the set flow time is ignored).
Configuring output signal and termination signals
See "Configuring output signal and termination signals" on Page 174.
180
Configurable selection
1 min to 60 min
Configurable selection Configurable selection Factory setting
On/Off
Signal
Input 1 to 4
Factory setting
–
activation.
Off
–