Removing Sws Be-F/Be-F Flow Wireless Bus Extenders From The Sws - schell 00 500 00 99 Anleitung Zur Inbetriebnahme

Commissioning
Commissioning the SWS network
After completing commissioning, information about the connected devices
can be requested and parameters set.
Path: Devices — All Devices
1.14.3 Removing SWS BE-F/BE-F Flow wireless bus extenders from the
If you want to remove an SWS BE-F/BE-F Flow wireless bus extender from
the SWS network to use it in another network (with a different Water Man-
agement Server), you must first remove the assignment of the SWS BE-F/
BE-F Flow wireless bus extender to the current server.
If the assignment is not removed, the SWS BE-F/BE-F Flow wireless bus ex-
tender cannot be detected by another server.
To do this, proceed as follows:
» Restart the commissioning.
The current network assignment is shown in the commissioning network de-
vice list.
» Deselect the SWS BE-F/BE-F Flow wireless bus extender that is to be re-
moved from the network (click to remove the tick mark).
» Save the reduced selection.
The SWS BE-F/BE-F Flow wireless bus extender is now no longer assigned to
the Water Management Server and is now again visible to other servers.
Battery-operated SWS BE-F/BE-F Flow wireless bus extenders must be re-
moved using the menu item "Devices / Device Name / Administration / Re-
move device from network".
Please note:
After being removed from the network, the BE-F/BE-F Flow wireless bus ex-
tender or wireless manager must not be disconnected from the power supply
for at least 5 minutes. During this time, the network structure is adjusted and
corresponding information stored in the system.
164
Fig. 15: Displaying all devices (fittings) after commissioning
SWS network