Transport; Loading The Vehicle - Kärcher MC 130 Classic Bedienungsanleitung

Removing the sweeping system
Remove the sweeper system in the reverse sequence to the at-
tachment procedure. Set the sweeping system down on the pal-
let. Remove the sweeping brushes first.
Always first depressurise the system before disconnecting the
hydraulic hoses, see the corresponding section in the vehicle op-
erating instructions.

Transport

Loading the vehicle

DANGER
Risk of injury due to incorrect transport
Mind the weight of the vehicle.
Slowly and carefully drive the vehicle onto the transport vehicle.
ATTENTION
Damage to vehicle
Do not load the vehicle with the crane.
Do not use a forklift.
1. Slowly drive the vehicle onto the transport vehicle.
Note
If the vehicle is not ready for running, see Chapter Towing the ve-
hicle.
Fastening the transport lock to the articulated joint
Bolt with safety cotter
1
Transport lock
2
Transport lock storage
3
1. Pull out the safety cotters.
2. Pull out both bolts.
3. Remove the transport lock out from storage.
4. Attach the transport lock.
5. Insert the bolts.
6. Lock the bolts with safety cotters.
96
WARNING
Danger of accident
Secure the vehicle against slipping during transport.
1. Park the vehicle.
2. Secure the vehicle with lashing straps on both sides at the il-
lustrated lashing points.
Note
If the vehicle with waste container is loaded in reverse for trans-
port, the cover of the waste container must be additionally se-
cured with a strap to prevent it from opening.
Note
The towing eye with retaining pin and locking pin are located in a
storage compartment under the passenger seat.
Towing eye
1
Retaining pins
2
Locking pin
3
Locking pin for bolt
4
Bolt
5
1. Open the storage compartment under the passenger seat and
remove the towing eye.
English
Securing the vehicle
Towing the vehicle
Fitting the towing eye