Kärcher MC 130 Classic Bedienungsanleitung Seite 88

Front parking support
1
Safety lever with retaining clips
2
Brakes
3
11.Set the switchover valve to the tilting attachment frame posi-
tion. See chapter .
12.Raise the attachment frame with waste container.
13.Push in the front parking supports as far as they will go and
secure them. To do this, press the safety lever down and push
in the supports as far as they will go. Then secure the safety
lever with the retaining clip.
14.Lower the attachment frame.
15.Actuate the roller brakes on the front parking supports.
Note
The waste container now stands free on the parking supports.
16.Drive the rear of the vehicle carefully out from under the waste
container.
Sweeping system
Removing the sweeping system
A changing carriage is required for attaching/removing the
sweeper system.
Note
Optional accessory, order no. 2.852-065.0.
1. Stop the vehicle on level, solid ground and secure it against
rolling away.
2. Raise the side brushes and extend both side brushes out-
wards.
Brush system unlocked lever position
1
Brush system locked lever position
2
Vehicle front
3
88
(1)Rod
(2)Locking lever
3. Unlock the sweeping system by inserting the rod and pulling
the locking lever upwards.
The rod needed for this is clamped in a holder between the
driver's seat and passenger seat.
4. Use the lift truck to move the changing carriage centrally in-
wards as far as it will go.
Move the last distance (centring process) faster.
Note
Risk of damage! Watch out for cables and hoses.
5. Raise the lift truck until the changing carriage makes contact
with the sweeper system.
Side brush arm
1
End stop
2
6. Retract both side brush arms.
7. Check the side brush arms for correct seating.
English